Building…

Cap holder for slatwall

Not test-printed yetBuilding…

Colours

Puts this design back in its own colours. Designs you haven't coloured show their own colours too, until you pick new ones.

Set your own measurements

Size

Width

Across the wall: the form and the mount behind it. An adult cap's crown is about 160 mm wide inside; 100 mm holds its sides out

Crown form

Form height

Up and down inside the cap's opening; 100 mm suits most adult caps

Form depth

How far the form reaches into the crown. Deeper holds a stack of nested caps

Holds: Cap
Kind: Cap holder
Prints as: One piece
Needs: Nothing to buy

Print settings, already in the 3MF

Worked out from your setup once the part has built.

Cap holder

Holds: Cap

Prints as 1 piece

Holds a baseball cap, or a few nested caps, on an open form that fills the crown. Hang the cap over the form with the brim pointing down; lift it up and forward to take it off. Print in PETG or ASA, not PLA.

CC BY 4.0 · Free

Not test-printed yet. Made with AI and checked against the rules on every wall, but no test print has confirmed it yet.

Walls it fits

VEVOR PVC slatwallFits · some wall sizes assumed · not test-printed yet
StoreWallFits · some wall sizes assumed · not test-printed yet
HandiwallFits · some wall sizes assumed · not test-printed yet
Trusscore SlatWallFits · some wall sizes inferred · not test-printed yet
Retail MDF slatwall, 3 inFits · some wall sizes inferred · not test-printed yet
Flow WallFits · some wall sizes assumed · not test-printed yet
Gladiator GearWallWon't fit: its slot opening is 17 mm, and the cam-lock mount needs a slot opening from 8.5 to 11 mm
ProSlat PVC slatwallWon't fit: ProSlat doesn't publish its slot. Measure your wall and use Custom

History

First published 8 Oct 2026 1.0.0

More for cap

Everything for cap ›