Power-strip cradle on slatwall, holding a power strip

Building…

Power-strip cradle for slatwall

Not test-printed yetBuilding…

Colours

Puts this design back in its own colours. Designs you haven't coloured show their own colours too, until you pick new ones.

Set your own measurements

Power strip

Strip width

Front to back of the power strip lying face up, at its widest point.

Strip length

End to end of the power strip's housing. The arms sit 40 mm in from the ends (at most 250 mm apart), so the cord and the switch at the ends stay clear.

Strip height

Bottom to top face of the strip. The front lips rise to half of it, so they hold the strip without reaching the outlets.

Holds: Power strip
Kind: Power-strip cradle
Prints as: 2 pieces
Needs: Nothing to buy

Print settings, already in the 3MF

Worked out from your setup once the part has built.

Power-strip cradle

Holds: Power strip

Prints as 2 pieces

Holds a power strip you buy face up on two arms, clear of its cord and switch. It drops in and lifts straight out, so hold it while you unplug. Enter the strip's length, width and height, and print in PETG or ASA, not PLA.

CC BY 4.0 · Free

Not test-printed yet. Made with AI and checked against the rules on every wall, but no test print has confirmed it yet.

Walls it fits

VEVOR PVC slatwallFits · some wall sizes assumed · not test-printed yet
StoreWallFits · some wall sizes assumed · not test-printed yet
HandiwallFits · some wall sizes assumed · not test-printed yet
Trusscore SlatWallFits · some wall sizes inferred · not test-printed yet
Retail MDF slatwall, 3 inFits · some wall sizes inferred · not test-printed yet
Flow WallFits · some wall sizes assumed · not test-printed yet
Gladiator GearWallWon't fit: its slot opening is 17 mm, and the wide cradle needs a slot opening from 8.5 to 11 mm
ProSlat PVC slatwallWon't fit: ProSlat doesn't publish its slot. Measure your wall and use Custom

History

First published 8 Oct 2026 2.0.0

More for power strip

Everything for power strip ›