Trash-bag roll holder on slatwall, holding a roll of trash bags

Building…

Trash-bag roll holder for slatwall

Not test-printed yetBuilding…

Colours

Puts this design back in its own colours. Designs you haven't coloured show their own colours too, until you pick new ones.

Set your own measurements

Settings

Largest roll diameter

Measure the fattest roll you buy. The seat is 6 mm wider, so the roll turns freely

Bracket width

Also the mount width. Wider is stronger and gives the roll end more to sit on; 32 mm or more for heavy rolls

Holds: Trash bags
Kind: Trash-bag roll holder
Prints as: One piece
Needs: Nothing to buy

Print settings, already in the 3MF

Worked out from your setup once the part has built.

Trash-bag roll holder

Holds: Trash bags

Prints as 1 piece

Holds a roll of trash bags in two open saddles, so you pull a bag down and tear it off. It needs no dowel, so coreless rolls work. A pair is rated 3 kg, about what a contractor-bag roll weighs, so weigh it first; print in PETG or ASA, not PLA.

CC BY 4.0 · Free

Not test-printed yet. Made with AI and checked against the rules on every wall, but no test print has confirmed it yet.

Walls it fits

VEVOR PVC slatwallFits · some wall sizes assumed · not test-printed yet
StoreWallFits · some wall sizes assumed · not test-printed yet
HandiwallFits · some wall sizes assumed · not test-printed yet
Trusscore SlatWallFits · some wall sizes inferred · not test-printed yet
Retail MDF slatwall, 3 inFits · some wall sizes inferred · not test-printed yet
Flow WallFits · some wall sizes assumed · not test-printed yet
Gladiator GearWallWon't fit: its slot opening is 17 mm, and the cam-lock mount needs a slot opening from 8.5 to 11 mm
ProSlat PVC slatwallWon't fit: ProSlat doesn't publish its slot. Measure your wall and use Custom

History

First published 8 Oct 2026 1.0.0

More for trash bags

Everything for trash bags ›